Contents

[S6 II] First Setup

Follow these steps before using your S6 II for the first time.

1. Check the Package

After unboxing, compare the contents with your order and make sure all included parts and accessories are present. Check the device and accessories for any visible shipping damage.

2. Perform an Initial Device Check

Place the S6 II horizontally on a stable, flat surface. Connect the power supply and press the Power Button.

After a brief startup sequence, the linkage arms will slowly move to their initial position.

Check that:

  • The connection points of the short linkage arms are level with each other.
  • The linkage arms remain stationary after initialization, with no unusual vibration or noise.
  • The OLED display clearly shows the device name, firmware version, wireless connection status, internal temperature, and fan speed.
  • The cooling fan automatically operates at Low, Medium, or High speed according to the internal temperature.

3. Install Accessories

Turn off the S6 II and disconnect the power before installing accessories.

Install any applicable accessories in the following order:

Desk Mount → MiraLube → T-Valve → Twist Receiver / Open Receiver

Skip any accessory that is not included with your configuration.

Important: We recommend installing the Twist Receiver or Open Receiver while the device is powered off. If installation must be performed while the device is powered on, support the rotating ring from underneath with one hand to prevent excessive rotation that could damage the Twist servo.

4. Power On & Continue Setup

Reconnect the power supply and press the Power Button.

After a brief self-check, the linkage arms will slowly move to their default position.

You can then continue setup using MiraPlay AiO 2.0 (recommended) or MiraPlay Web.

Next: Calibration & Range Settings →

Share this article on SNS

Leave a Comment

Your email address will not be published. Required fields are marked *


Shopping Cart